Le forum (ô combien francophone) des utilisateurs de Powerbuilder.
Bonjour
Après avoir installer un webservice sur un serveur sur lequel pb11.5 n'est pas installé j'ai systematiquement l'erreur suivant quand je fais appel au webservice coté client :
The specified module could not be found. (Exception from HRESULT: 0x8007007E)
Description: An unhandled exception occurred during the execution of the current web request. Please review the stack trace for more information about the error and where it originated in the code.
Exception Details: System.IO.FileNotFoundException: The specified module could not be found. (Exception from HRESULT: 0x8007007E)
Source Error:
An unhandled exception was generated during the execution of the current web request. Information regarding the origin and location of the exception can be identified using the exception stack trace below.
Stack Trace:
[FileNotFoundException: The specified module could not be found. (Exception from HRESULT: 0x8007007E)]
Sybase.PowerBuilder.Web.WebGlobal.Application_Start(Object sender, EventArgs e) +0
--------------------------------------------------------------------------------
Version Information: Microsoft .NET Framework Version:2.0.50727.42; ASP.NET Version:2.0.50727.42
J'ai trouvé cela
Exception from HRESULT: 0x8007007E This error can be caused by
different versions of PowerBuilder 11.0 .NET assemblies in the server
environment. To resolve this issue, remove extra copies of PowerBuilder 11
.NET assemblies from the Global Assembly Cache (GAC), leaving only the
latest copies of each assembly.
Mais j'ai qu'une seule version
Avez vous une autre idée ?
Merci
Hors ligne
If the error in IE is “Exception from HRESULT: 0x8007007E”
The most likely cause is that different versions of the PowerBuilder 11.0 .NET
assemblies are installed in the environment.
o Check whether different versions of the PowerBuilder 11.0 .NET
assemblies exist in folders or in the GAC (Global Assembly Cache).
o If present, remove older versions and leave only the latest version of the
assembly.
If the error is “the page cannot be displayed” or “404 file not found”
o Check the folders under \wwwroot\ to see if related folders and files
have been generated.
o Check if you are using a TCP port number other than the default 80.
If you fail to open the page from a remote client
o Try pinging the server to make sure it is accessible.
o Check if the firewall is on on the server that you are accessing. If yes,
turn it off and open the page again.
Hors ligne
JCZ a écrit:
Mais j'ai qu'une seule version
rien d'autre sur le serveur mise à part les dll pb 11.5 ( d'eval )
Hors ligne